Skip to main content

Changes to Step #8

Edit by Ron Davis

Edit approved by Ron Davis

Deleted
Added
Unchanged

Step Lines

[* black] Position a wire to the corresponding connection point on the jack.
[* black] Carefully apply a small amount of solder to hold the wire in place.
[* black] Repeat this for each wire.
[* icon_reminder] Make sure to reference the mapping of wires to connection points that you created in Step 4.
[* icon_note] When soldering the wires, be patient and meticulous about getting the right position to make a good connection.
[* icon_note] If the internal wires do not have their own insulation, use a small bit of shrink tubetubing on each wire. This will prevent them from shorting across another wire.
[* icon_note] If the internal wires do not have their own insulation, use a small bit of shrink tubetubing on each wire. This will prevent them from shorting across another wire.