Changes to Step #8
Edit by Matthew Vaught —
Edit approved by Matthew Vaught
- Deleted
- Added
- Unchanged
Step Lines
| [* black] Position a wire to the corresponding connection point on the jack. |
| [* black] Carefully apply a small amount of solder to hold the wire in place. |
| [* black] Repeat this for each wire. |
| [* icon_reminder] Make sure to reference the mapping of wires to connection points that you created in Step 4. |
| [* icon_note] When soldering the wires, be patient and meticulous about getting the right position to make a good connection. |