Skip to main content

Fix Your Stuff

Right to Repair

Store

Changes to Step #2

Edit by Andrew Bookholt

Pending approval

Before
After
Unchanged

Step Lines

[* black] Starting with the battery cell closest to the dock connector, run a plastic opening tool underneath the edge of the battery closest to the logic board void to make enough room to insert the flat end of a spudger
[* black] Run the flat end of a spudger along the two long sides of each battery cell to completely separate them from the adhesive securing them to the rear case.
[* icon_caution] If the adhesive is very difficult to separate, reheat the rear panel and try again.

Image 1

No previous image

Added

Image 2

No previous image

Added