Skip to main content

Changes to Step #2

Edit by Richdave

Pending approval

Deleted
Added
Unchanged

Step Lines

[* black] Gently push the '''THIN''' wires through the rubber end cap to create a bit of a loop on the rear of the assembly.
[* black] Using a plastic pry tool you can pop the rubber end cap out and then lift the thin wires out of the groove in the rear of the CCFL assembly
[* icon_note] Note the thin wires are held in the groove by a small amount of adhesive.
[* black] Run the pry tool the length of the assembly and free the wires all the way to the other end cap
[* black] gently pop the rubber end cap out of the assembly

Image 2

No previous image

Added

Image 3

No previous image

Added