Skip to main content

Changes to Step #1

Edit by Richdave

Pending approval

Deleted
Added
Unchanged

Step Lines

[* black] Remove the white tape from the rear of each end of thethe CCFL assembly
[* red] Carefully remove about 15-20mm of heat shrink from the CCFL cable to allow the end cap to be removed, making sure you '''DO NOT''' cut or nick the wire insulation.
[* black] Remove the white tape from the rear of each end of thethe CCFL assembly
[* red] Carefully remove about 15-20mm of heat shrink from the CCFL cable to allow the end cap to be removed, making sure you '''DO NOT''' cut or nick the wire insulation.
[* icon_caution] The wires have a '''HIGH VOLTAGE''' applied during operation and the insulation may break down if damaged causing a short
[* violet] While holding the assembly, slowly and gently pull the thick wires up and out of the slots in the white rubber cap.
[* icon_caution] Pull the wires one at a time ensuring you don't flex the CCFL and break it.
[* yellow] This will reveal the pins and solder joints.