Skip to main content

Changes to Step #3

Edit by Andrew Optimus Goldheart

Edit approved by Andrew Optimus Goldheart

Deleted
Added
Unchanged

Step Lines

[* black] Lift the end of the AirPort board up enough to pass over the heat sink directly behind it.
[* icon_caution] Do not lift the AirPort board too high, you could damage the contacts or socket.
[* black] Pull the AirPort board straight out of its socket on the logic board.
[* icon_note] There is a slightly adhesive thermal pad beneath the AirPort board. Be sure to reapply this when reinstalling the board, or transfer it to your replacement board.