Skip to main content

Changes to Step #12

Edit by Vladislav Killiakov

Edit approved by Vladislav Killiakov

Before
After
Unchanged

Step Lines

-[* red] Locate the ribbon cable underneath the "Wi-Fi" print.
-[* orange] Use the flat end of the plastic spudger to release the plastic clamp on the ribbon cable connector
-[* yellow] Insert the pointed end of the plastic spudger into a small hole on the side of the ribbon cable and pull the ribbon cable out of its housing.
+[* black] Use the flat end of the plastic spudger to release the plastic clamp on the ribbon cable connector
+[* black] Insert the pointed end of the plastic spudger into a small hole on the side of the ribbon cable and pull the ribbon cable out of its housing.