Skip to main content

Changes to Step #12

Edit by Chandler Mang

Edit approved by Chandler Mang

Before
After
Unchanged

Step Lines

-[* black] Locate the ribbon cable underneath the Wi-Fi print.
-[* black] Insert a plastic spudger into a small hole on the side of the ribbon cable and pull the ribbon cable out of its housing.
+[* black] Locate the ribbon cable underneath the "Wi-Fi" print.
+[* black] Use the flat end of the plastic spudger to release the plastic clamp on the ribbon cable connector
+[* black] Insert the pointed end of the plastic spudger into a small hole on the side of the ribbon cable and pull the ribbon cable out of its housing.