Skip to main content

Fix Your Stuff

Right to Repair

Store

Changes to Step #3

Edit by Evan Noronha

Edit approved by Evan Noronha

Before
After
Unchanged

Step Lines

[* black] Pull up on the suction cup with firm, constant pressure to create a slight gap between the front panel and rear case.
[* icon_note] Take your time and apply firm, constant force. The display assembly is a much tighter fit than most devices and is held down with adhesive.
[* icon_caution] Pulling too hard may damage the display assembly. Apply just enough pressure to create a small gap between the display assembly and the rear case.