Skip to main content

Fix Your Stuff

Right to Repair

Store

Changes to Step #2

Edit by KarlD

Pending approval

Before
After
Unchanged

Step Lines

[* icon_note] Do not lift the logic board out completely without first disconnecting the DC-In connector underneath the logic board.
[* black] Lift the logic board partly up from the optical side.
[* black] When reassembling, make sure the black wire at the top of the logic board is not folded before being routed up through the indent at the top middle left of the logic board. If this is the case, the wire will be too short for later reassembly steps.