Skip to main content

Changes to Step #5

Edit by Steve

Pending approval


Step Lines

[* black] Turn the computer over and open it up.
-[* black] Remove the following 13 screws:
+[* black] Remove the following 14 screws:
[* red] Six 2.5 mm Phillips on either side of the keyboard area.
[* orange] Five 4.5 mm Phillips on the left half of the keyboard area.
[* yellow] One 7 mm hex in the upper left corner of the upper case (a T6 Torx driver will do the job nicely).
[* green] One 15 mm Phillips in the upper middle of the keyboard area.
[* blue] One 16.5 mm hex in the upper right of the upper case (again, a T6 Torx driver will work well).