Skip to main content

Changes to Step #5

Edit by iRobot

Pending approval

Before
After
Unchanged

Step Lines

+[* black] Turn the computer over and open it up.
+[* black] Remove the following 13 screws:
+ [* red] Six 2.5 mm Phillips on either side of the keyboard area.
+ [* orange] Five 4.5 mm Phillips on the left half of the keyboard area.
+ [* yellow] One 7 mm hex in the upper left corner of the upper case (a T6 Torx driver will do the job nicely).
+ [* green] One 15 mm Phillips in the upper middle of the keyboard area.
+ [* blue] One 16.5 mm hex in the upper right of the upper case (again, a T6 Torx driver will work well).

Image 1

No previous image

Added