Skip to main content

Changes to Step #5

Edit by mayer

Pending approval

Before
After
Unchanged

Step Lines

[* black] The board is held in place with a small Phillips screw.
[* black] Ater removing the screw the board can be gently extricated from the tube.
[* black] Note the red and black wires. This connector inserts laterally. The wires go to the battery receptor in the middle of the tube.
+[* black] The screw is in two parts, a phillips screw goes into a post screw. The top screw holds in the board and the post screw holds the On/Off switch in place.