Changes to Step #10

Edit by Ashley Frazee

Edit approved by Ashley Frazee

Deleted
Added
Unchanged

Step Lines

[* black] You will now need to removeRemove the large wire ribbon located under the screw removed in step seven.
[* black] You will now need to removeRemove the large wire ribbon located under the screw removed in step seven.
[* black] Gently wiggle the ribbon in an upward motion.
[* black] This should be done by adjusting a pair of needle nose tweezers horizontally in order to grasp a greater surface area. This will increase a safer amount of leverage needed to remove ribbon.
[* icon_note] You can push the black part of the camera where the buttons and dials are for easier access. Just be sure not to push too hard as it may break the plastic.