Skip to main content

Fix Your Stuff

Right to Repair

Parts & Tools

Changes to Step #8

Edit by Jerry Hess

Edit approved by Andrew Optimus Goldheart

Before
After
Unchanged

Step Lines

[* black] Remove the two yellow wire ribbons seen in this photo.
[* black] With a pair of needle nose tweezers very gently lift the black/grey latch open towards the wire ribbon. (the plastic latch rotates upward to release and snaps down to lock, be very careful not to break this latch, it cannot be replaced)
[* black] With a pair of needle nose tweezers very gently lift the black/grey latch open towards the wire ribbon. (the plastic latch rotates upward to release and snaps down to lock, be very careful not to break this latch, it cannot be replaced)
[* black] After opening black/grey latch proceed to gently remove wire ribbon with needle nose tweezers.
[* black] Pull the wire ribbon towards the back end of the camera.
[* black] Repeat the process with the larger wire ribbon.