Changes to Step #5

Edit by Carson Cleveland

Edit approved by Kelsea Weber

Deleted
Added
Unchanged

Step Lines

[* black] The motherboard is now connected in only one place on the edge of the device. Being careful of this, flip the motherboard outside of the device, leaving it connected to the foam padding inside of the device.
[* black] Using the metal spudger, carefullyCarefully pry the small rectangle apart from the thin strip of foam.
[* black] If the foam is still intact you may leave the foam in order to reattach the new motherboard.
[* black] Using the metal spudger, carefullyCarefully pry the small rectangle apart from the thin strip of foam.
[* black] If the foam is still intact you may leave the foam in order to reattach the new motherboard.