Skip to main content

Changes to Step #4

Edit by Kelsea Weber

Edit approved by Kelsea Weber

Deleted
Added
Unchanged

Step Lines

[* black] In order to be able to better work with the motherboard we disconnecttitle] Disconnect the microphone which is hidden underneath the motherboard.
[* red] To start remove aRemove the strip of adhesive tape located underneathunder the motherboard near the location of the two screws removed in the previous step. The area where the strip is at is highlighted in the first picturemotherboard.
[* black] Gently prylift the mother board towards the side with the 4 wire connection as shown inmotherboard to expose the pictureinner components.
[* orange] The wire connectingUse a spudger to scrape away the microphone near the bottom of the motherboard opposite side of the adhesive tape previously removed will be held down by adhesive and some foam that will be needed to be scraped offconnecting the microphone.
[* yellow] Once the wire has more slack after removing the foam and adhesive unscrewUnscrew the 4mm phillips head screw holding the microphone in place.
[* black] The microphone screw and adhesive foam are shown in the picture.
[* black] In order to be able to better work with the motherboard we disconnecttitle] Disconnect the microphone which is hidden underneath the motherboard.
[* red] To start remove aRemove the strip of adhesive tape located underneathunder the motherboard near the location of the two screws removed in the previous step. The area where the strip is at is highlighted in the first picturemotherboard.
[* black] Gently prylift the mother board towards the side with the 4 wire connection as shown inmotherboard to expose the pictureinner components.
[* orange] The wire connectingUse a spudger to scrape away the microphone near the bottom of the motherboard opposite side of the adhesive tape previously removed will be held down by adhesive and some foam that will be needed to be scraped offconnecting the microphone.
[* yellow] Once the wire has more slack after removing the foam and adhesive unscrewUnscrew the 4mm phillips head screw holding the microphone in place.
[* black] The microphone screw and adhesive foam are shown in the picture.