Changes to Step #4
Edit by Kelsea Weber —
Edit approved by Kelsea Weber
- Before
- After
- Unchanged
Step Lines
[* black] |
[* black] |
[* red] To start remove a strip of adhesive tape located underneath the motherboard near the location of the two screws removed in the previous step. The area where the strip is at is highlighted in the first picture. |
[* black] Gently pry the mother board towards the side with the 4 wire connection as shown in the picture. |
[* orange] The wire connecting the microphone near the bottom of the motherboard opposite side of the adhesive tape previously removed will be held down by adhesive and some foam that will be needed to be scraped off. |
[* yellow] |
[* yellow] |
[* black] The microphone screw and adhesive foam are shown in the picture. |