Fix Your Stuff

Right to Repair

Store

Changes to Step #2

Edit by Kelsea Weber —

Edit approved by Kelsea Weber

Before
After
Unchanged

Step Lines

[* blackred] Using the plastic spudger gently pry along the middle of the 2 sections of the plastic housing in order to release plastic latches on the inside of the housing.
[* blackicon_note] Unlike the parent unit there are no wires across the two housing pieces, so once the latches are undone simply pull it apart without worry of disconnecting anything.
[* red] The housing is highlighted above the general area where the latches are in the second image of this step.
[* blackred] Using the plastic spudger gently pry along the middle of the 2 sections of the plastic housing in order to release plastic latches on the inside of the housing.
[* blackicon_note] Unlike the parent unit there are no wires across the two housing pieces, so once the latches are undone simply pull it apart without worry of disconnecting anything.
[* red] The housing is highlighted above the general area where the latches are in the second image of this step.