Changes to Step #2
Edit by Jean Carlos —
Edit approved by Jean Carlos
- Before
- After
- Unchanged
Step Lines
[* black] Using the plastic spudger gently pry along the middle of the 2 sections of the plastic housing in order to release plastic latches on the inside of the housing. |
[* black] Unlike the parent unit there are no wires across the two housing pieces, so once the latches are undone simply pull it apart without worry of disconnecting anything. |
[* red] The housing is highlighted above the general area where the latches are in the second image of this step. |
Image 1
No previous image
Added
Image 2
No previous image
Added