Skip to main content

Fix Your Stuff

Right to Repair

Store

Changes to Step #1

Edit by Andrew Optimus Goldheart

Edit approved by Andrew Optimus Goldheart

Before
After
Unchanged

Step Lines

[* black] While holding the front panel open at about a 90ยบ angle, remove the following screws securing the front panel assembly cable bracket:
[* red] Three 1.3 mm Phillips #00 screws
[* orange] One 3.0 mm Phillips #00 screw
[* icon_caution] Don't lose track of this screw! It's very important that the one 3.0 mm screw goes in the top-right corner of the plate. Anywhere else may cause damage to the logic board.