Skip to main content

Fix Your Stuff

Right to Repair

Store

Changes to Step #11

Edit by Jeff Suovanen

Edit approved by Jeff Suovanen

Before
After
Unchanged

Step Lines

[* black] Remove the card and re-insertagain slide it underneathunder the centertop edge of the battery, starting from top. Slidenear the card in as far as it will go, breaking up as much adhesive as you cancenter.
[* black] Remove the card and re-insertagain slide it underneathunder the centertop edge of the battery, starting from top. Slidenear the card in as far as it will go, breaking up as much adhesive as you cancenter.
[* icon_caution] Be extremely careful to slide the card '''over''' the front-facing camera and headphone jack cables to avoid cutting them.
[* black] Slide the card in as far as it will go, breaking through as much of the adhesive as you can.
[*
black] Lift up on the card to pry the second battery cell up from the rear case.
[* black] Slide the card in as far as it will go, breaking through as much of the adhesive as you can.
[*
black] Lift up on the card to pry the second battery cell up from the rear case.
[* icon_note] If there is significant resistance from the battery when you try to pry it up, reheat the adhesive with an iOpener and repeat the previous 3 steps to break apart the adhesive as necessary.