Skip to main content

Changes to Step #26

Edit by Jeff Suovanen

Edit approved by Jeff Suovanen

Deleted
Added
Unchanged

Step Lines

[* black] Slide a plastic card underneath the center of the motherboard, pushing it in as far as it will go.
[* black] Slowly pryswing the left edge of the entire motherboard upup, while making sure it doesn't snag against any of the disconnected cables.
[* black] Slowly pryswing the left edge of the entire motherboard upup, while making sure it doesn't snag against any of the disconnected cables.
[* icon_caution] If any portion of the motherboard requires excessive force to pry up, stop prying, re-apply the iOpener, and re-perform the corresponding guide steps to fully release the adhesive.