Skip to main content

Changes to Step #2

Edit by Dante Mazzanti

Edit approved by Dante Mazzanti

Before
After
Unchanged

Step Lines

[* icon_note] Orient the glass panel lengthways so that the camera and heart rate sensor holes are to your left.
[* black] Grasp the adhesive from both sides and align the tape over the rear glass.
[* black] Lower the bottom edge of [* icon_note] Make sure to align the camera and heart rate sensor holes on the camera and adhesive tape onto the glasstape.
[* black] Slide your right hand upLay the sideadhesive on top of the adhesive film and lower the film onto the glass.
[* black] Lower the bottom edge of [* icon_note] Make sure to align the camera and heart rate sensor holes on the camera and adhesive tape onto the glasstape.
[* black] Slide your right hand upLay the sideadhesive on top of the adhesive film and lower the film onto the glass.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added