Skip to main content

Changes to Step #6

Edit by bymyhand

Pending approval

Deleted
Added
Unchanged

Step Lines

[* icon_note] If you are replacing the power & sensor cable with a new unit, use the edge of a plastic opening tool to peel the electronic power switch off its metal bracket.
[* black] Transfer the bracket to your new power & sensor cable.
[* black] Make sure to move all foam pieces to the new cable/sensor.
[* black] Also do not forget the block that is covering the sensors when you install the new cable.
[* black] To make sure the proximity sensor will work, you must move the foam covered screen over from the original proximity sensor.

Image 2

No previous image

Added