Skip to main content

Changes to Step #5

Edit by Jake Devincenzi

Edit approved by Jake Devincenzi

Deleted
Added
Unchanged

Step Lines

[* black] Grab the power & sensor cable near the microphone and peel it off the front panel, being careful not to rip it in the process.
[* black] It is important toicon_caution] Take note the following (locate the gold square at the end of the right side of the ribbon): the gold square isgold, rectangular microphone attached vertically to the wall of the phone chassis with black foam.
[* black] [experts: please insert how
case. Take care not to removerip it fromwhen removing the chassis wall here. shall it be removed using a fingernail between the wall of the chassis and the black foam behind the gold square? or shall it be peeled up from the bottom while pulling on the cable (i would think it would rip)] ?cable.
[* black] It is important toicon_caution] Take note the following (locate the gold square at the end of the right side of the ribbon): the gold square isgold, rectangular microphone attached vertically to the wall of the phone chassis with black foam.
[* black] [experts: please insert how
case. Take care not to removerip it fromwhen removing the chassis wall here. shall it be removed using a fingernail between the wall of the chassis and the black foam behind the gold square? or shall it be peeled up from the bottom while pulling on the cable (i would think it would rip)] ?cable.