Skip to main content

Changes to Step #5

Edit by Sam Kassis

Edit approved by Jake Devincenzi

Deleted
Added
Unchanged

Step Lines

[* black] Grab the power & sensor cable near the microphone and peel it off the front panel, being careful not to rip it in the process.
[* black] It is important to note the following (locate the gold square at the end of the right side of the ribbon): the gold square is attached vertically to the wall of the phone chassis with black foam.
[* black] [experts: please insert how to remove it from the chassis wall here. shall it be removed using a fingernail between the wall of the chassis and the black foam behind the gold square? or shall it be peeled up from the bottom while pulling on the cable (i would think it would rip)] ?