Skip to main content

Changes to Step #5

Edit by Alyceson-Grace Eke

Edit approved by Alyceson-Grace Eke

Before
After
Unchanged

Step Lines

-[* icon_caution] Place the driver flat on a table before completely separating the two halves of the housing so components don't fall out during opening.
-[* black] Pry apart the two halves of the housing at the back side of the driver using the metal spudger .
+[* icon_caution] Place the driver flat on a table before completely separating the two halves of the housing so components of the drill don't fall out during opening.
+[* black] Pry apart the two halves of the housing at the back side of the driver using the metal spudger.
[* icon_note] The housing is easier to remove if you pry from multiple sides.