Skip to main content

Changes to Step #5

Edit by Nathan Hoyt

Edit approved by Nathan Hoyt

Before
After
Unchanged

Step Lines

-[* black] Pry apart the two halves of the housing using the metal spudger.
-[* icon_note] Pry multiple sides of the housing before you attempt to open it completely
+[* icon_caution] Place the driver flat on a table before completely separating the two halves of the housing so components don't fall out during opening.
+[* black] Pry apart the two halves of the housing at the back side of the driver using the metal spudger .
+[* icon_note] The housing is easier to remove if you pry from multiple sides.