Skip to main content

Changes to Step #4

Edit by Andrew Yoder

Edit approved by Andrew Yoder

Deleted
Added
Unchanged

Step Lines

[* black] Use your [product|IF145-046|wire stripper] to expose about 2cm of the the wire.
[* black] You must also remove the plastic coating from each smaller, individual wire by using a wire stripper, fine sandpaper, or something of that sort.
[* icon_note] If you attempt to solder the wires without removing the plastic coating, the connection most likely will not work.
[* black] You must also remove the plastic coating from each smaller, individual wire by using a wire stripper, fine sandpaper, or something of that sort.
[* icon_note] If you attempt to solder the wires without removing the plastic coating, the connection most likely will not work.