Skip to main content

Changes to Step #2

Edit by Andrew Yoder

Edit approved by Andrew Yoder

Deleted
Added
Unchanged

Step Lines

[* black] SlideUsing a voltmeter (set in Ohms to test resistance), test each terminal on the plastic casing frombase of the replacement jack onto the wire.
[* icon_note] Make sure casing is facing the correct way. We need
plug to be ablesee which terminal corresponds to slidewhich speaker (left or right).
[* black] Image 3 shows which part of
the casing over the replacement jack after attaching itplug corresponds to the wire.each cable:
[* red] Right
[* green] Left
[* yellow] Common (or ground)
[* black] SlideUsing a voltmeter (set in Ohms to test resistance), test each terminal on the plastic casing frombase of the replacement jack onto the wire.
[* icon_note] Make sure casing is facing the correct way. We need
plug to be ablesee which terminal corresponds to slidewhich speaker (left or right).
[* black] Image 3 shows which part of
the casing over the replacement jack after attaching itplug corresponds to the wire.each cable:
[* red] Right
[* green] Left
[* yellow] Common (or ground)

Image 2

Old Version

New Version

Image 3

Old Version

New Version