Skip to main content

Changes to Step #3

Edit by peteralstone

Pending approval

Deleted
Added
Unchanged

Step Lines

[* icon_note] Removing the following screw isn't strictly necessary, but it will make the next step easiereasier and will make it much easier to install the new battery later.
[* black] Remove the black T6 Torx screw from near the battery connector on the logic board. If you are very careful not to strip the screw, a small flat or phillips head screwdriver will work, but a torx bit is much easier to work with and less likely to strip the screw.
[* icon_note] Removing the following screw isn't strictly necessary, but it will make the next step easiereasier and will make it much easier to install the new battery later.
[* black] Remove the black T6 Torx screw from near the battery connector on the logic board. If you are very careful not to strip the screw, a small flat or phillips head screwdriver will work, but a torx bit is much easier to work with and less likely to strip the screw.