Changes to Step #2
Edit by Adam Yerly —
Edit approved by Adam Yerly
- Before
- After
- Unchanged
Step Lines
[* black] With the motherboard facing you, use the pointy end of your Spudger to gently separate the two speaker's connectors. [* icon_caution] This connector type requires being lifted out of place, not pulled. Accidentally pulling may damage the wires. |
[* black] With the motherboard facing you, use the pointy end of your Spudger to gently separate the two speaker's connectors. [* icon_caution] This connector type requires being lifted out of place, not pulled. Accidentally pulling may damage the wires. |
[* icon_reminder] During reassembly, make sure the speaker's connectors are not pushed behind the motherboard. |
[* red] Use your #00 Phillips Screwdriver to remove the seven 2 mm screws. |