Skip to main content

Changes to Step #8

Edit by Matthew Newsom

Pending approval

Before
After
Unchanged

Step Lines

-[* icon_note] Turn the console around so that the front panel is facing to the right and the right panel is facing toward you.
-[* black] Insert the spudger into the rear-most slit on the right edge of the bottom bezel, and wedge it behind the clip by pushing the spudger down while pushing the tip of the spudger against the right panel.
+[* icon_note] Turn the console around so that the faceplate is facing to the right and the right case is facing toward you.
+[* black] Insert the spudger into the rear-most slit on the right edge of the bottom bezel, and wedge it behind the clip by pushing the spudger down while pushing the tip of the spudger against the right case.
[* black] Simultaneously release the clip and pull the bottom bezel up.
[* icon_note] This clip is especially hard to remove. Some force will be required to insert the spudger correctly.