Skip to main content

Changes to Step #6

Edit by Matthew Newsom

Pending approval

Before
After
Unchanged

Step Lines

-[* icon_note] Start in the rear left corner of the device, below the hard drive slot. This clip is not one of the clips marked in red.
-[* black] Insert a metal spudger through the slit at the rear left of the bottom plate.
-[* black] Simultaneously pull up on the top panel and rotate the spudger away from the console to free the clip.
+[* black] Insert a metal spudger through the slit near the rear left corner of the bottom bezel.
+[* black] Rotate the spudger away from the device while lifting the rear bezel up with the other hand.
[* icon_note] You may hear a "pop" signifying the clip has cleared its catch.