Skip to main content

Changes to Step #1

Edit by Beth Hotchkiss

Edit approved by Beth Hotchkiss

Before
After
Unchanged

Step Lines

[title] Removing the top black wire
+[* icon_caution] Unlike the other ribbon wire connectors, the white connector (in this step only) is not attached to the ribbon wire. It can not, and should not, be pulled out completely.
[* red] Locate the white connector where the top black ribbon wire attaches to the green and black circuit board.
-[* icon_caution] The white connector acts as a grip on the wire and, unlike the other ribbon wire connectors, should not be pulled out completely.
[* black] Pinch the tabs on the white connector and pull it partially out.
-[* black] Hold the black ribbon wire directly and pull it out.
+[* black] Hold the black ribbon wire directly and pull it the rest of the way out.