Skip to main content

Changes to Step #1

Edit by Michael Ebert

Edit approved by Michael Ebert

Before
After
Unchanged

Step Lines

[title] Removing the top black wire
-[* red] Pinch and pull the tabs on the upper clasp located on the black side of the green and black circuit board.
+[* red] Locate the white connector where the top black ribbon wire attaches to the green and black circuit board.
+[* icon_caution] The white connector acts as a grip on the wire and, unlike the other ribbon wire connectors, should not be pulled out completely.
+[* black] Pinch the tabs on the white connector and pull it partially out.
[* black] Hold the black ribbon wire directly and pull it out.
-[* icon_note] The white clasp acts as a grip on the wire and should not pull out completely.