Skip to main content

Changes to Step #4

Edit by Liam

Edit approved by Liam

Before
After
Unchanged

Step Lines

[title] Remove antenna and disconnect the PCB board
-[* black] Remove the two screws, using a Phillip's head screwdriver, at the bottom right corner of the front panel as shown in the image.
- [* red] Two 3.35mm Philip Screws
+[* black] Remove the two screws at the bottom right corner of the front panel using a Phillips head screwdriver, as shown in the image.
+ [* red] Two 3.35mm Philips head Screws
[* orange] Use tweezers to disconnect the antenna from the logic board to the PCB board.
-[* black] Remove the tape connected on the logic board.
+[* black] Remove the tape connected to the motherboard.