Skip to main content

Changes to Step #4

Edit by Liam

Edit approved by Liam

Before
After
Unchanged

Step Lines

[title] Remove antenna and disconnect the PCB board
[* black] Remove the two screws, using a Phillip's head screwdriver, atscrews at the bottom right corner of the front panel using a Phillips head screwdriver, as shown in the image.
[* black] Remove the two screws, using a Phillip's head screwdriver, atscrews at the bottom right corner of the front panel using a Phillips head screwdriver, as shown in the image.
[* red] Two 3.35mm Philip Screws
[* orange] Use tweezers to disconnect the antenna from the logic board to the PCB board.
[* black] Remove the tape connected on the logic board.