Skip to main content

Changes to Step #4

Edit by Liam

Edit approved by Liam


Step Lines

[title] Remove the pcb board
[* black] Remove the two screws, using a Phillip's head screwdriver, at the bottom right corner of the front panel as shown in the image.
[* black] Use tweezers to disconnect the antenna from the docking connector PCB board. You can now remove the board and set it aside.
[* black] Gently pry, using a plastic opening tool, and pull out the logic board slightly.
[* icon_caution] Before removing the logic board, release the power button from the frame and also disconnect the volume button using a tweezer to avoid tearing them.
[* black] Remove the tape connected on the logic board.