Skip to main content

Changes to Step #4

Edit by Blain Abebe

Edit approved by Blain Abebe


Step Lines

+[* black] Remove the two screws, using a Phillip's screwdriver, at the bottom right corner of the front panel as shown in the image.
+[* black] Use tweezers to disconnect the antenna from the docking connector PCB board. You can now remove the board and set it aside.
+[* black] Gently pry, using a plastic opening tool, and pull out the logic board slightly.
+ [* icon_caution] Before removing the logic board, release the power button from the frame and also disconnect the volume cables/button using a tweezer to avoid tearing them.
+[* black] Remove the tape connected on the logic board.