Skip to main content

Changes to Step #4

Edit by Blain Abebe

Edit approved by Blain Abebe

Before
After
Unchanged

Step Lines

[* black] Remove the two screws, using a Phillip's head screwdriver, at the bottom right corner of the front panel as shown in the image.
[* black [* red] Two 3.35mm Philip Screws
[* orange
] Use tweezers to disconnect the antenna from the two docking connectorslogic board to the PCB board.
[* black [* red] Two 3.35mm Philip Screws
[* orange
] Use tweezers to disconnect the antenna from the two docking connectorslogic board to the PCB board.
[* black] Remove the tape connected on the logic board.

Image 2

Old Version

New Version