Skip to main content

Changes to Step #4

Edit by Nyles Peterson

Edit approved by Nyles Peterson

Before
After
Unchanged

Step Lines

[* black] Remove the two screws, using a Phillip's head screwdriver, at the bottom right corner of the front panel as shown in the image.
[* black] Use tweezers to disconnect the antenna from the two docking connectorconnectors to the PCB board.
[* black] Use tweezers to disconnect the antenna from the two docking connectorconnectors to the PCB board.
[* black] Remove the tape connected on the logic board.

Image 1

Old Version

New Version

Image 2

Old Version

New Version