Skip to main content

Changes to Step #4

Edit by Blain Abebe

Edit approved by Blain Abebe

Before
After
Unchanged

Step Lines

[title] Remove the pcb board
[* black] Remove the two screws, using a Phillip's head screwdriver, at the bottom right corner of the front panel as shown in the image.
[* black] Use tweezers to disconnect the antenna from the docking connector PCB board. You can now remove the board and set it aside.
[* black] Use tweezers to disconnect the antenna from the docking connector PCB board. You can now remove the board and set it aside.
[* black] Remove the tape connected on the logic board.

Image 1

Old Version

New Version

Image 2

No previous image

Added