Skip to main content

Changes to Step #5

Edit by Nyles Peterson

Edit approved by Nyles Peterson

Before
After
Unchanged

Step Lines

[title] Removing theRemove PCB board
[title] Removing theRemove PCB board
[* black] Remove the tape holding the battery in place.
[* black] Gently lift the battery from the bottom using a plastic opening tool.
[* icon_note] You may have to apply heat to melt the glue holding the battery in place.
[* icon_caution] Do not completely remove the battery yet
[* black] You can now disconnect the flex cable holding the PCB board place. Gently open the gates using a plastic opening tool and use a tweezer to slide the flex cable out.
[* black] You can now remove the board and set it aside.