Skip to main content

Changes to Step #1

Edit by skat1140

Edit declined by Walter Galan

Deleted
Added
Unchanged

Step Lines

[title] Lower Case
[* black] Remove the following ten screws securing the lower case to the upper case:case. (While the 13.5mm screws insert straight in, the 3mm screws insert at an angle perpendicular to the curve of the unibody: to unscrew them do ''not'' apply pressure straight down, but tilt the screwdriver slightly so its perpendicular to the curve.)
[* black] Remove the following ten screws securing the lower case to the upper case:case. (While the 13.5mm screws insert straight in, the 3mm screws insert at an angle perpendicular to the curve of the unibody: to unscrew them do ''not'' apply pressure straight down, but tilt the screwdriver slightly so its perpendicular to the curve.)
[* orange] Three 13.5 mm (14.1 mm) Phillips screws.
[* red] Seven 3 mm Phillips screws.