Skip to main content

Changes to Step #6

Edit by Kyle Smith

Edit approved by Kyle Smith

Before
After
Unchanged

Step Lines

[* black] Remove the battery from the iPhone.
[* icon_note] If your replacement battery came in a plastic sleeve, remove the sleeve before installation by pulling it away from the the ribbon cable.
+[* icon_reminder] If there's any alcohol solution remaining in the phone, carefully wipe it off or allow it to air dry before installing your new battery.
[* icon_reminder] Before you adhere the replacement battery, temporarily reconnect the battery connector to the logic board socket. This ensures that the battery is properly aligned in its recess.
[* black] Adhere the battery, disconnect it, and continue reassembling your device.
[* icon_reminder] If your new battery doesn’t have adhesive preinstalled, refer to [guide|56465|this guide] to replace the adhesive strips.
[* icon_reminder] Perform a [guide|44409|hard reset] after reassembly. This can prevent several issues and simplify troubleshooting.