Skip to main content

Changes to Step #3

Edit by Richdave

Pending approval

Before
After
Unchanged

Step Lines

-[* icon_caution] Pull the fan out of the plate but do not completely detach it from the board.
-[* black] Remove the metal plate.
+[* icon_caution] Lift the plate and lower fan off the heat sink being careful not to damage the lower fan cable which is attached to the logic board
+[* green] Disconnect the lower fan connector from the logic board
+[* black] Remove the metal plate and lower fan.
+[* icon_note] The lower fan will easily separate from the metal plate

Image 1

Old Version

New Version