Changes to Step #4
Edit by Arthur Shi —
Edit approved by Arthur Shi
- Before
- After
- Unchanged
Step Lines
| + | [title] Alternate heating method |
|---|---|
| + | [* icon_note] If you don't have a microwave, follow this step to heat your iOpener in boiling water. |
| + | [* black] Fill a pot or pan with enough water to fully submerge an iOpener. |
| + | [* black] Heat the water to a boil. ***Turn off the heat.*** |
| + | [* black] Place an iOpener into the hot water for 2-3 minutes. Make sure the iOpener doesn't make prolonged contact with the pot, or it may melt. |
| + | [* black] Use tongs to extract the heated iOpener from the hot water. |
| + | [* black] Thoroughly dry the iOpener with a towel. |
| + | [* icon_caution] The iOpener will be very hot, so be careful to hold it only by the end tabs. |
| + | [* black] Your iOpener is ready for use! If you need to reheat the iOpener, heat the water to a boil, turn off the heat, and place the iOpener in the water for 2-3 minutes. |
Image 1
No previous image
Added
Image 2
No previous image
Added