Changes to this Step
Edit by Keane Stokes —
Edit approved by Marty Rippens
- Before
- After
- Unchanged
Step Lines
| - | [* black] Using the Phillips #00 Screwdriver, remove the four 6.0 mm screws securing the rear cover to the controller. |
|---|---|
| + | [* black] The plastic shell is held in place by little plastic tabs that snap together. |
| + | [* black] Wedge the plastic opening tool between the shell and the controller and carefully pry off the plastic. |
| + | [* icon_note] Take your time on this step. You do not want to break any plastic pieces. |